Home > Die & Mould > Plastic Mould > News



Priamus System Technologies AG


Company \| News \| Products \| Contact Us

FILLCONTROL: Automatic Valve Gate Control for Cold Runners

9/17/2013

In hotrunner technology control systems are successfully used since many years for the automatic balancing of multi cavity molds. This is because the simultaneous filling of all cavities is a precondition for the optimum part quality. These conditions are achieved by automatically detecting the melt front in the single cavities and by controlling the temperature of the hotrunner nozzles in case of deviations.

For cold runner molds - for instance in case of liquid silicone rubber applications - it is even more important to achieve an equal filling because otherwise the different volumes in the cavities will also cause a different compression after cross-linking. The results are unfilled respectively inhomogeneous parts which sporadically occur in one or the other cavity.

The solution for this problem is again the automatic detection of the melt front via cavity pressure or cavity temperature sensors and the automatic delay of the valve gate opening until an equal filling will be achieved. There is a choice of either balancing the average fill time or to control the desired target fill time.

This control method can be used for thermoplastics as well as for liquid silicone rubbers or elastomers. Likewise it can be used to balance and control conventional multi cavity molds as well as family molds.

FILLCONTROL is a modular system to monitor and control the injection molding process. For the automatic valve gate control the new Control V module comes into operation.

In Mold Labeling (IML) Pilot Cell at StackTeck 5/31/2013

Synventive Continues Expansion in Japan 7/17/2012

Novel injection moulding process from Mecaplast could cut car part weights in half 6/21/2012

SPE Thermoforming Division Announces Call for Entries in Parts Competition 5/9/2012

INCOE® Introduces NEW Valve Gate Tip Designed for Fast Color Change Applications 5/3/2012

INCOE® Introduces SoftGate® Advanced Sequential Control Performance to Global Markets 5/3/2012

INCOE® Expands "Request For Quotation" Program adding Temperature Controllers and Single Nozzle Systems 5/3/2012

INCOE® Introduces NEW Edge Gate System Technology 5/3/2012

Weld Line Prediction: From Injection Molding Simulation to Structural Simulation 4/11/2012

Plastic Mould Exhibitions
	PLAST 2026 6/9/2026 - 6/12/2026 Milan, Italy
	InterMold Thailand 2026 6/17/2026 - 6/20/2026 Bangkok, Thailand
	Rotomould 2026 6/22/2026 - 6/24/2026 Melbourne, Australia
	DMC 2026 7/1/2026 - 7/4/2026 Shanghai, China
	PDMEX 2026 7/23/2026 - 7/25/2026 Manila, Philippines
More Trade Shows